Not fun but you got to do it, cleaning the tap lines. #homebrew #homebrewing. I broke down the beer tap and soaked it in PBW. Then I cleaned all the lines with line cleaner and reassemble. #home #brewing

Just about any good home brewer will tell you that one of the first rules of home brewing beer and making good home brewed beer is cleanliness. Unfortunately humans are not the only beer lovers on the planet.  Beer is loved by everything from insects to bacteria and your homebrewing and keg systems are highly susceptible to bacterial growth. Beer lines, keg fittings and taps are often times places where the like to hang out and they should be cleaned regularly.  Thankfully there are several products out there to help you keep your systems sanitary and your beer tasting good!

After building my Kegerator setup which you can view here, I knew that I would need to care for it and clean my taps so I purchased the line cleaning kit and some liquid beer line cleaner which is shown above.  The kit was great, it came with instructions and everything that I needed in order to do the job. The beer keg line cleaning kit came with a 1 quart hand pump that pushes Beer Line Cleaner through the draft beer system. The faucet gets removed and cleaned with the included faucet wrench and brush.  The process is relatively quick and easy and takes about 20 minutes to clean a couple beer taps out.

If you are interest in purchasing a draft beer line cleaning kit you can find it here:

Keg line cleaning kit

Keg Line Cleaning Solution

Here are the detailed instructions on how to clean your keg beer lines, beer taps and beer faucets:

1) Remove the tap from the keg. Use a beer faucet wrench to remove the faucet (the piece that the beer actually flows though to your glass) from the draft beer shank. The beer faucet collar should have a few holes in it, insert the wrench end into a hole and spin the collar clockwise to remove.

2) Next, disassemble the faucet to the point that the shaft inside can slide out. Place these parts in a bowl with 2 cups of warm water and ¼ teaspoon of Beer Line Cleaner. Put one cap full of beer line cleaner into the beer line pump jar and fill with warm water. Attach the lid pump unit back on the jar. Get a bucket to collect the fluid running from the tap. Insert the cleaning brush small end into the bottom of the tap to allow the flow to go through if needed.

3) Pump the cleaning solution though line and tap allowing the solution to sit in the lines for 10–15 minutes, then pump through. Follow this with 1–2 jars of water to rinse. Remove the brush from the tap.

4) Use the brush and a towel to clean the draft beer faucet and then rinse with clean water. Reassemble the faucet, hand tighten parts, leave loose enough so that they move freely. Attach the faucet back onto the shank again, using the wrench, do not over tighten, just tighten enough so that it does not leak any precious beer!